After connecting this panel to your RAMPS board

See an animated preview of your build sequence

1x Bowden tube 1x Belt 1x Complet Hot End with heater and thermister 1x Push Fit 2x Delrin 2x Endstop 1x Pliers 1x Insulating Tape

1 Prepare the area where the NextDent LC-3D Print BOX will stand:

SpiderPowderSpringSteel System - Ex Ender-3 V2 - 235x235mm Andre brands 3DE Nylon After connecting this panel toSmart SpiderPOWDERSpringSteel Sheet System with mounted PEI. Including top and bottom plate (PowderSpringSteel Sheet and magnetic base) Size: 235x235mm Suitable for: End 3 Ender 3 Pro Ender 3 V2 End 4 Ender 5 Pro CR 20 Pro CP 01 Note: Does not fit Ender 5 S1 Qualities: *Easy to install *Easy to use *Good adhesion No additional adhesives required *Easy to remove your item from the build plate after printing ! NOTE ! If you are in doubt about what size