* 'Must Have' for you with 3D printer

Connectivity

Firmware can use the same configuration as RAMPS1

BOFA air filter and 7-inch touch screen make it a user-friendly

TPM - Wash Solvent - 5L Craftbot - Reservedel * 'Must Have' for youWash Solvent TPM Wash Solvent (Tripropylene glycol monomethyl ether) is a non flammable, low odor solvent that can be used to clean and dissolve uncured resin on SLA DLP 3D printed parts. TPM has a lower evaporation rate than IPA and washes about three times as many parts as IPA before it needs to be replaced. * Compatible with Formlabs Finish Kit, Form Wash and Form Cure * 5 litres ! ATTENTION ! TPM is not currently certified for use with Formlabs